duct tape




Want to learn how to make this flower pen that you will be bragging on for a while? Follow the directions below and you will do great!




      1.     Take a strip of duct tape however long you want, mine was about 7 inches. Then cut it in half, length wise.




                   2.              Cut both strips into squares. Like in the picture above.




 3.  Take one of the squares and fold one of the corners down. Then fold the other corner next to it down so the top looks like a triangle..
                                                             



               4.    Wrap around pencil or pen. Repeat steps 2 & 3 until you run out of tape, then you repeat every step. Move your petals sown as you work. like the picture below. In the process of making the flower make sure your petals move down like the picture below.




                   5.     Your flower should look like this in the middle of the process. If you wanted to switch colors now is the time. When it gets to this size.

                   
                                 When your done it should look close to this. But of course in different colors


                                                      Duct Tape Flip Flops



                                  

                                           
     These duct tape flip flops will make you the coolest girl on the block! They are so much fun to make and you can were them! If your friends want to make them, which they probably will, you are going to have to tell them how and this is  is the perfect place to get the instructions. Look down to find the steps to being cool!


         
              1.          First you take a piece of card board and then trace your foot or one of your shoes.




                2.                                Cut the traced figure out



               3.             Wrap the cut out figure with the duct tape of your choice



                4.         Poke a hole where your two toes would be. Make sure you go through both cardboard and duct tape. Put this away for awhile


                 5.               For the strap take a long piece of tape, mine was about 1 and1/2 feet.


              6.            Take the bottom and fold it half way  up. Like in the picture.


              7.          Then take the top and fold it down and then you have your strap!


               8.             Take the strip and fold it in half. Then stick the folded part in the hole. As shown in the picture


                 9.           Put your foot on the flip flop, then fit the straps so they fit your foot.



              10.               Tape the straps on the back so they will stay. And tape the other part of the strap on the back too! If you did all these steps right it should look something like the picture on the home page



                                                    Duct Tape Wallet





 This wallet is very useful especially if you have money to put in it. ha ha ha ha! I have a wallet like this and I find it very useful. This is a cute thing that doesn't take long to make. The instructions on how to make the wallet are below.




                 1.       Take two pieces of duct tape about 7 maybe 6 inches long and overlap them a little bit. Like picture above.





                   2.             Do the same thing again then put them on top of each other so each side is red or whatever color you chose. Cut them so they are even. not to much or you won't be able to put pockets or dollar bills in it. Repeat steps one and two.


       



               3.               Put the two sheets together and then tape them together. Tape the bottom and sides so you have a pocket. like the picture below



                                                    It should look like this



                 4. If you want to make pockets, follow these instructions.
                           1.   Take a strip of tape a little bigger than a credit card.
                           2.    Then take a strip that is the exact same length  the card.
                           3.   Take those two strips and stick them on top of each other, make sure to leave room on both sides, so you can stick it on the wallet
                           4.   Now put it on the inside of your wallet on the side so you can close it evenly.
                           5. You can put more pockets on by following these instructions.

                                               
                                                  When you are done it should look like this!